Micromod MOD: Modcell 2050R Users Guide Manual de usuario Pagina 75
- Pagina / 228
- Tabla de contenidos
- SOLUCIÓN DE PROBLEMAS
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
IB-23C650
SETUP
Table 3. Digital Input Setup Menu
Middle
Display
Bottom
Display
Entry Description
LOCKOUT YES
NO
= Locks out the front panel ramp/soak
commands indicated
R/H,RSET = Run/hold, reset commands
locked if run/stop selected
RUN/HOLD = Run/hold commands
locked if run/hold selected
SKIP = Skip commands locked if
run/skip selected
= Allows all front panel commands to the
ramp/soak algorithm
Also see note in 2.1.2 above.
DI2 FUNC RUN/STOP
RUN/RSET
RUN/HOLD
= If DI closed: start counting at preset value
If DI open: reset and stop at preset value
= If DI closed: continue from current count
If DI open: reset and begin counting from
preset value
= If DI closed: continue from current count
If DI open: stop and hold current count
LOCKOUT YES
NO
= Locks out the front panel totalizer
commands indicated
R/H,RSET = Run/hold, reset commands locked
if run/stop selected
RESET = Reset commands locked if
run/reset selected
RUN/HOLD = Run/hold commands
locked if run/hold selected
= Allows all front panel commands to the
totalizer algorithm
Also see note in 2.1.2 above.
LOCKOUT YES
NO
= Locks out the front panel selection of active
set-point
= Allows front selection of active set-point
When both digital inputs are used for set-point
selection, this choice applies to both. They are
not independent.
Also see note 2.1.2 above.
69
- User’s Guide 1
- MicroMod Automation, Inc 2
- CONTENTS 3
- CONTENTS (Cont’d) 4
- ILLUSTRATIONS 5
- ILLUSTRATIONS (Cont’d) 6
- IDENTIFICATION INFORMATION 8
- IB-23C650 10
- INTRODUCTION 10
- INSTALLATION 11
- MOUNTING 13
- WIRING GUIDELINES 14
- S-3017-7A(3) 15
- POWER CONNECTIONS 16
- GROUND CONNECTIONS 17
- Electrical Noise 17
- REMOTE SET-POINT CONNECTIONS 18
- RTD INPUT 21
- VOLT INPUT 24
- MILLIVOLT INPUT 25
- DIGITAL INPUT 26
- Minimum Resistance: 27
- No External Parts: 500 ohms 27
- OUTPUT SIGNAL CONNECTIONS 28
- Receiver 30
- Precision Dropping Resistor 30
- Maximum Value: 400 ohms 30
- Blank Page 32
- GENERAL PREPARATIONS 33
- SETUP FUNCTIONS 34
- SETUP METHOD 34
- SETUP CONTROLS 34
- DATA BASE REFERENCE TABLES 34
- to advance to Step 3.5 54
- Table 2. Input Setup Menu 55
- to advance to Step 4.7 60
- (i. e. ,100% = 20 mA dc) 79
- Table 6. RS-485 Setup Menu 86
- Table 8. Set-Point Setup Menu 93
- to advance to Step 7 98
- to return to Step 1 98
- to advance to Step 7.10.8 108
- (Step 3 or 4) 109
- Table 11. Alarm Settings Menu 115
- Table 12. Tune Menu 121
- BASIC OPERATION 129
- CONTROL KEYS 131
- ENGINEERING DISPLAYS 132
- STATUS DISPLAYS 133
- Top & Middle 135
- BAR GRAPHS 136
- ALARM INDICATOR 136
- . If diagnostic 137
- OPERATION IN AUTOMATIC MODE 138
- AUTO/MANUAL TRANSFER 142
- OPERATION IN MANUAL 144
- Enabling Digital Inputs 149
- One Digital Input 151
- CONTROL OUTPUT LIMITING 152
- Alarm Messages 155
- Alarm Trip Points 155
- Alarm Priority 155
- Beep on Alarm Occurrence 155
- Alarms with Acknowledgment 155
- Alarm Type Messages 156
- MANUAL TUNING 159
- key to set 160
- I = P (Minutes) 161
- AUTOMATIC TUNING 163
- Setup Procedure 163
- Table 13. Autotune Procedure 167
- STEP SIZ (Step 5) 168
- Table 13. Autotune Procedure 169
- to advance to: 170
- RAMP/SOAK OPERATION 175
- OPERATION IN AUTOMATIC 177
- CONTROLLING RAMP/SOAK PROFILE 179
- Ramp or Soak Hysteresis 181
- Ramp/Soak Hold 181
- TOTALIZER OPERATION 183
- Totalizer Status Display 184
- Totalizer Reset Display 184
- Preset Value 185
- Predetermined Count 185
- RATIO BIAS CONTROL 189
- Control Method 190
- Ratio Function 190
- Bias Function 191
- A/M RATIO BIAS STATION 193
- Instrument Set-up 195
- A/M Switching 195
- TIME PROPORTIONING CONTROL 197
- S-1107-41B 198
- CURRENT PROPORTIONING CONTROL 199
- DESCRIPTION 201
- S-1107-248A 202
- S-1107-52A 202
- ON/OFF CONTROL 203
- DIAGNOSTICS 207
- Input Failure Messages 208
- Operational Failure Messages 208
- TROUBLESHOOTING 209
- Problem Possible Cause Action 210
- CALIBRATION DATA 211
- MAINTENANCE 220
- RECORD OF DATABASE 221
Relacionado con productos y manuales para Equipo Micromod MOD: Modcell 2050R Users Guide
(38 paginas)© 2020, manymanuals.es. Todos los derechos reservados | 0.053 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales