Micromod MOD: Modcell 2050R Users Guide Manual de usuario descargar pdf (Pagina 39)

IB-23C650

SETUP

Table 1. Base Configuration

Middle

Display

Bottom

Display

Entry Description

3. Be sure that any length of thermocouple

extension wire or RTD lead wire used in

the installation is connected for this proce-

dure. If it is not possible to use the exten-

sion or lead wire, an equivalent resistor

should be used.

4. When using a melting ice bath as a

temperature standard, put melting ice and

water mixture in a thermos to establish a

precise 32°F (0°C) temperature which is

within the range of most thermocouples

and RTDs used with the controller.

5. An alternate method for an RTD is to con-

nect a 100-ohm 0.1% resistor to the RTD

lead wires in place of the actual RTD. The

Primary display should read 32°F (0°C)

because a standard RTD (DIN Std 43760)

has a resistance of 100 ohms at 32°F.

ENABLE NO

YES

= Don’t allow INPUT 2 SETUP in INPUTS

**MENU** or REM (remote setpoint) select

display.

= Allow input 2 setup and remote setpoint

select display.

TYPE

MILLIAMP

VOLT

THERMCPL

RTD

MILLIVLT

SLIDEWIR

Input types are:

= 0 to 54 mA dc input

= 0 to 6 V dc input

= Thermocouple input

= RTD input

= –10 to 120 mV dc input

= 0 to 100% slidewire (potentiometer) wiper

position

TC TYPE TYPE * Where * = J, K, E, R, S, T, B, or N.

The type of thermocouple selected must match

the type connected to the Input 2 terminals.

TEMP CAL This procedure is provided to compensate for

variations in individual RTDs or thermocouples.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 227 228

Comentarios a estos manuales

Sin comentarios

Micromod MOD: Modcell 2050R Users Guide Manual de usuario Pagina 39

Comentarios a estos manuales

Relacionado con productos y manuales para Equipo Micromod MOD: Modcell 2050R Users Guide