Micromod MOD: Modcell 2050R Users Guide Manual de usuario descargar pdf (Pagina 45)

IB-23C650

SETUP

Table 1. Base Configuration

Middle

Display

Bottom

Display

Entry Description

CALIBRAT NO

YES

= Don’t repeat the procedure.

= Repeat the calibration procedure.

Note: If NO is selected, the calibration will

remain bad.

UP MSG NO

YES

= Don’t hold ‘POWER FAILED’ message at

power-up.

= Hold ‘POWER FAILED’ message at

power-up until scroll key is pressed.

MODE LAST

AUTO

MANUAL

= Power up in the same mode (Auto/Manual)

as at power down.

= Power up in auto mode.

= Power up in manual mode.

ENABLE NO

YES

= Don’t allow RAT BIAS **MENU** setup or

RAT variable select display.

= Allow Ratio Bias setup and display.

With this option enabled, ratio and bias values

(local or remote) are applied to the process

variable to directly affect output without using

the PID algorithm (no set-point used). The

output calculation is:

Output = Process Variable x Ratio + Bias

ENABLE NO

YES

= Don’t allow AUTOTUNE setup and ATN

variable select display.

= Allow auto tune setup and display.

See Automatic Tuning in Operation section for

setup and operation procedure.

ENABLE NO

YES

= Don’t allow RAMPSOAK **MENU** setup or

RSK variable select display.

= Allow ramp-soak setup and display.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 227 228

Comentarios a estos manuales

Sin comentarios

Micromod MOD: Modcell 2050R Users Guide Manual de usuario Pagina 45

Comentarios a estos manuales

Relacionado con productos y manuales para Equipo Micromod MOD: Modcell 2050R Users Guide