Micromod MOD: Modcell 2050R Users Guide Manual de usuario descargar pdf (Pagina 139)

IB-23C650

BASIC OPERATION

Automatic Operation with Remote or Multiple Set-Points

The controller may be in either auto or manual as selected in the power up

mode section of the BASE CFG MENU. If the controller is in automatic, the

front face will resemble the example below.

Note: Remote set-point requires the option board be installed.

[AUT] indicates that the controller is in

automatic.

The set-point may be [LOC], [LO2],

[LO3], [LO4] or [REM], depending on

which set-points were enabled in the

SETPTS MENU.

Bottom status display indicates lower

engineering display is showing the

current set-point and its engineering

units label.

Press

to change set-point

variable .

Press the scroll key to display the

output in percent in the lower

engineering display.

[OUT] appears in the third status

display (output cannot be changed in

automatic).

H or C indicates Heat or Cool if

controller was configured for heat/cool

operation.

Press the scroll key again to return the

set-point in the lower engineering

display.

133

1 2 ... 134 135 136 137 138 139 140 141 142 143 144 ... 227 228

Sin comentarios

Micromod MOD: Modcell 2050R Users Guide Manual de usuario Pagina 139