Micromod MOD: 30ML Operation and Template Setup Manual de usuario descargar pdf (Pagina 77)

MOD 30ML Operation

APPENDIX A - EVENT CODES

A-15

Table A-2. Event Codes, Description and Action

Block

Type

Codes Full Message Text Description/Action

RIO 4 I/O MISMATCH A configured slot is either empty or the installed

module does not match the slot configuration.

RIO 5 CS-31 BUS COMMUNICATION ERROR There is an error in communication or loss of

communication between the RIO interface

module and the CS-31 bus.

RIO 6 I/O COMMUNICATIONS ERROR An error occurred in communication between

the RIO module and the instrument.

RIO 7 CS-31 DATABASE CHECKSUM ERROR The remote I/O database stored in the interface

module has been declared bad due to a

checksum error.

RIO 8 MODULE EXTENDED ERROR There is an RIO module error.

RSK 0 BLOCK STATE SET TO RUN Information only.

RSK 1 BLOCK STATE SET TO HOLD Information only.

RSK 2 BLOCK STATE SET TO OFF Information only.

RSK 3 BLOCK STATE SET TO DEBUG Information only.

RTI 0 BLOCK STATE SET TO RUN Information only.

RTI 1 BLOCK STATE SET TO HOLD Information only.

RTI 2 BLOCK STATE SET TO OFF Information only.

RTI 3 BLOCK STATE SET TO DEBUG Information only.

RTI 4 CALCULATION ERROR A calculation error (calculation overflow or

divide by zero) has been detected. The block

completes the calculation using some

reasonable value (+ or - maximum value for

overflows and divide by zero), and sets the

output quality bad if Attribute No. 10, Set quality

bad on calculation error? (SETQBAD) is YES.

The diagnostic error clears and the quality is

set back to good when a subsequent execution

of the block performs a successful calculation.

RTTI 0 BLOCK STATE SET TO RUN Information only.

RTTI 1 BLOCK STATE SET TO HOLD Information only.

RTTI 2 BLOCK STATE SET TO OFF Information only.

RTTI 3 BLOCK STATE SET TO DEBUG Information only.

RTTI 4 CALCULATION ERROR A calculation error (calculation overflow or

divide by zero) has been detected. The block

completes the calculation using some

reasonable value (+ or - maximum value for

overflows and divide by zero), and sets the

output quality bad if Attribute No. 10, Set quality

bad on calculation error? (SETQBAD) is YES.

The diagnostic error clears and the quality is

set back to good when a subsequent execution

of the block performs a successful calculation.

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 83 84

Comentarios a estos manuales

Sin comentarios

Micromod MOD: 30ML Operation and Template Setup Manual de usuario Pagina 77

Comentarios a estos manuales

Relacionado con productos y manuales para Equipo Micromod MOD: 30ML Operation and Template Setup