Micromod MOD: 1731N ICN Mini-Link Users Guide Manual de usuario

ICN Mini Link User’s Guide 1731N Model A – Mini Link Board for PC AT (Version 1) 1732N Model A – ICN Interface Board (Version 1)

IB-23C003INTRODUCTIONPERFORMANCE CHARACTERISTICS* Maximum ratings indicate limits beyond which permanent damage may occur. Continuous operation at th

IB-23C003INTRODUCTION1.5 RELATED DOCUMENTATIONAdditional reference information on ICN/Link communications can be found in the followingdocuments. • I

IB-23C003INTRODUCTION1-8

IB-23C003INSTALLATIONSECTION 2INSTALLATION2.1 PREPARING THE PERSONAL COMPUTERPrepare your PC/AT as follows:1. Turn off the system unit.2. Turn off all

IB-23C003INSTALLATION2.2 DETERMINING MINI LINK BASE ADDRESS/INTERRUPT LEVELThe total I/O address space required by the Mini Link is eight bytes in len

IB-23C003INSTALLATION2.4 SWITCH AND JUMPER SETTINGSThis section contains a brief description of the Mini Link switches and jumpers with anapplication

IB-23C003INSTALLATIONHardware Interrupts and Polarity for PC/AT Serial PortThe Mini Link hardware interrupt levels may be set as shown in Table 2-3.

IB-23C003INSTALLATIONTable 2-6. Mini Link External Serial Port Baud Rates* Not recommended for use with currently available software.BAUDJumper INW12

IB-23C003INSTALLATION2.4.2 ICNICN IsolationThe Mini Link is fitted with Opto-isolation components capable of providing a minimum of3000 VDC electrica

IB-23C003PROGRAMMING MINI LINK INTERRUPTSSECTION 3PROGRAMMING MINI LINK INTERRUPTS3.1 GENERALThe IBM PC/AT has reserved hardware interrupts for common

MicroMod Automation, Inc. The Company MicroMod Automation is dedicated to improving customer efficiency by providing the most cost-effective, applic

IB-23C003PROGRAMMING MINI LINK INTERRUPTSInterrupt Service Routine LocationIt is the user's responsibility to install an Interrupt Service Routin

IB-23C003TROUBLESHOOTING THE MINI LINKSECTION 4TROUBLESHOOTING THE MINI LINK4.1 NO RESPONSE FROM LINKFor software that polls Transmit Data Register Em

IB-23C003TROUBLESHOOTING THE MINI LINK4.3 FROZEN DISPLAY/NO RESPONSE FROM PC KEYBOARDThis type of problem is usually indicative of address or interrup

IB-23C003APPENDIX A - JUMPERS AND SWITCHESAPPENDIX AJUMPERS AND SWITCHESS-3002-134AFigure A-1. Switch and Jumper Locations for 1731N Mini LinkTable A

IB-23C003APPENDIX A - JUMPERS AND SWITCHESFigure A-2. Switch and Jumper Locations for 1732N ICN Interface BoardTable A-2. Alphanumeric Listing of Ju

IB-23C003APPENDIX B - CONNECTOR DESCRIPTIONSAPPENDIX B CONNECTOR DESCRIPTIONSTable B-1. IBM PC/AT Mini Link Board Connector Pinout* Currently in use

IB-23C003APPENDIX B - CONNECTOR DESCRIPTIONSTable B-2. Mini Link RS-232 Connector Pinout* Pin 9 can be configured to present Mini Link's 5VDC (f

The Company’s policy is one of continuous product improvement and the right is reserved to modify the information

IB-23C003CONTENTS––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––CONTENTSPageSECTION 1 - INTRODUCTION1.1

IB-23C003CONTENTS–––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––TABLESTable Page2-1 Personal Computer

IB-23C003INTRODUCTIONSECTION 1INTRODUCTION1.1 DESCRIPTIONThe 1731N Mini Link with 1732N ICN Interface Board, Figure 1-1, provides a generalpurpose ser

IB-23C003INTRODUCTIONPhysically the Mini Link is a PC/AT plug-in module which completely emulates the 1720NCommunications Link (refer to IB-23C001) fo

IB-23C003INTRODUCTIONBase NumberUnusedElectrical CodeICN InterfaceFirmwareModel/Design LevelSample Serial No. 1731N Z 10 1 01 A – 555Catalog NumberSeq

IB-23C003INTRODUCTION1.3.2 1732N ICN Interface BoardThe ICN Interface Board is an ICN controller card only and is used to add a second ICN tothe 1731N

IB-23C003INTRODUCTION1.4 TECHNICAL SUMMARYPOWER REQUIREMENTS1731N Mini Link Board for AT Style PC+5VDC at 0.8 Amp provided by personal computer+24VDC