Micromod MOD: 30ML Controller Operation and Maintenance Tra Manual de usuario descargar pdf (Pagina 57)

Training Manual

MOD 30ML Diagnostics Lab

4 - 9

4.5.2 Read the shutdown information and acknowledge it:

Step Procedure Comments

1 The first step in reading the

shutdown info is to cycle power the

controller. Power down the controller

and then power it.

After power up the DEVICE display will come up.

The instrument will be in default mode and Line 3

will display DEF as shown in the first figure below.

There will be diagnostic alarms and the RED LED

will be flashing.

2 View the diagnostic alarms by

pressing the ALARM button.

Acknowledge the alarms by pressing

the button next to UAK on the

display.

Go to the next alarm by pressing the

ALARM button again.

The diagnostic alarms that come up after an

instrument shut down are:

1. Instrument Power up

2. Instrument SHUTDOWN

3. Spurious Interrupt

Refer to the following figures

Figure 4 .7.

Figure 4 .8.

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 73 74

Sin comentarios

Micromod MOD: 30ML Controller Operation and Maintenance Tra Manual de usuario Pagina 57