Micromod MOD: 30ML Controller Operation and Maintenance Tra Manual de usuario descargar pdf (Pagina 39)

Training Manual

Single Loop Template Lab

3 - 17

3.3.9 Process Input Setup

1 Press NXT PROC INP will be displayed on line 2. We are

entering the process input setup for our PID

control loop.

2 Press DOWN This takes you into the process input definition

menus. SLOT will be displayed on line 2.

3 BI 1 AIN is the default input. We will

accept this.

This is Built-In Analog Input 1. Inputs may be

defined as NONE, BI AIN 1, BI AIN 2 or module

slot S01- to S11- for input being configured

4 Press NXT INP TYPE will be displayed on line 2.

Figure 3 .16.

5 VOLTS is the default for the process

input. Press UP and then ENT to change

this to CURRENT.

Input types may be defined as: VOLTS, MVOLTS,

CURRENT, RESIST, THRMOCPL

1 Slot: RTD2WIRE, CURRNT2W

2 Slots: RTD3WIRE, WIDERES

Built-in only: TC W/CJC, RTD

6 Press NXT until LO SIGNL is displayed

on Line 2

7 Press the DOWN arrow and FST/SLO

keys to change the low signal range to 4

Built-in analog input 1 is wired to a pot in the

demonstration unit which has a range of 0 to 6

Volts

8 Press NXT HI SIGNL is displayed on line 2

9 Use the UP and FST keys to change the

high signal range to 20 and press ENT

10 Press NXT until HI ENGU is displayed

on line 2

11 Use the UP/DOWN keys and the FST Pressing the Up key, will cause the Least

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 73 74

Sin comentarios

Micromod MOD: 30ML Controller Operation and Maintenance Tra Manual de usuario Pagina 39