Micromod MOD: 30ML Controller Operation and Maintenance Tra Manual de usuario descargar pdf (Pagina 35)

Training Manual

Single Loop Template Lab

3 - 13

Next, we will change some of the system alarm settings.

1 Press DOWN DIAGNSTC RATE is displayed on lines 1 and 2.

FAST = off 100mSec, on 300 mSec.

SLOW = off 250mSec, on 750mSec.

We will accept the FAST rate.

Alarm indication rates apply to light, display

and beeper. Alarms are: unacknowledged

diagnostics, high or low process and deviation

conditions, and input quality

2 Press NXT DIAGNSTC FLASH is OFF.

OFF = flashing is disabled.

ENABLE = flash display (LED always flashes

for diagnostic).

Press NXT. DIAGNSTC BEEP is OFF

OFF = beeping is disabled.

ENABLE = beep for diagnostic.

4 Press NXT

5 Set MINIMUM LOW PRI to 5 and press

ENT.

All process alarms with priority >= this value (2

- 255) are considered LOW priority for display

purposes.

6 Press NXT HIGH PRI RATE is FAST.

FAST = off 100mSec, on 300 mSec

SLOW = off 250mSec, on 750mSec

7 Press NXT

8 Set HIGH PRI FLASH to ENABLE and

press ENT

OFF = flashing is disabled

ENABLE = flash display on alarm

Figure 3 .13.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 73 74

Sin comentarios

Micromod MOD: 30ML Controller Operation and Maintenance Tra Manual de usuario Pagina 35