Micromod Micro-DCI: 53SL5100A Single Loop Controller Manual de usuario descargar pdf (Pagina 41)

Single Loop Process Controller Instruction Manual

Front Panel 33

3.3.4 Responding to the Prompt KEY?

When the password prompt KEY? appears, it indicates a password was set with an external device (e.g.,

Hand-Held Configurer, PC, etc.). The password can not be set via the front panel keys. A password key is

a maximum of 10 numeric characters (numbers 0-9 only). It does not impede display functions in EMODE

but must be unlocked to perform configuration functions.

✎ Notes A password key is NOT SET FOR NEW INSTRUMENTS from the

factory; therefore, if it is set, it had to have been done locally. The

password must first be obtained from the originator before the

procedure in Table 3-5 can be used to access the EMODE

configuration function capabilities.

Table 3-5. Entering a Key Password

Step Press

Shift

Result

Press to

Locate

Target

Char.

Result

MODE

Puts instrument in EMODE.

If CONFIGURE does not appear, press F2.

Displays password query: KEY? .

↑

Puts first password number on entry line:

KEY? .N.

← .N∆↑ N

Shifts N and puts second password number on

entry line: KEY? .NN.

← .NN∆ ↑ N

Shifts NN and puts third password number on entry

line: KEY? .NNN.

Repeat Step 6 until all of the password characters are entered.

It enters the password key and displays the entry

line: POINT . the EMODE configuration function is

now accessible for use.

Note:

∆ = space, N = any numeric value 0-9.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 151 152

Sin comentarios

Micromod Micro-DCI: 53SL5100A Single Loop Controller Manual de usuario Pagina 41