Micromod MOD: 30ML Functions Data Base Reference Manual de usuario descargar pdf (Pagina 37)

MOD 30ML Functions

DISPLAY INTERFACE BLOCK

Choose a display to appear on the instrument front face at power up.

DEVICE 0 Power up display is the *DEVICE* display (top level display).

USER Power up display is a user display from the Edit Display List. The

user field will be active to enter a display tag from the display list (the

display's position in Display List is stored as number).

PREVIOUS 65535 Power up display is the previous display.

15 Current Display (CURDISP) ............................................................................................. – – R

Display currently on the faceplate (stored as display number).

16 Current Access Level (CURACCS) ................................................................................. – – R

Current level of access.

OPERATE 0 Base operating level.

TUNE 1 Tune access enabled.

CONFIGURE 2 Configure access enabled.

17 Access Timeout (ACCTIME) ............................................................................................ C – –

The time in minutes (1 - 54) that the tune and configure access levels will timeout and return

to the operate level after last keyboard activity.

NONE 0 No timeout. Current access level will not timeout and change.

USER 1 to 54 Current access level will timeout and change 1 to 54 minutes after

last keyboard activity. Enter 1 to 54 in the subsequent field.

18 Min Low Alarm Priority (MINLOPRI) .............................................................................. C – R

All process alarms with priority >= this value (2 - 255) are considered LOW priority for display

purposes.

19 Diagnostics: Display Flash (FLSHDIAG) .......................................................................CWR

Use to specify if an unacknowledged diagnostic will cause the entire display to flash. The

LED always flashes on an unacknowledged diagnostic.

NO 0 display flashing is disabled for an unacknowledged diagnostic.

YES 1 an unacknowledged diagnostic will cause the entire display to flash.

20 Diagnostics: Beep (BEEPDIAG)......................................................................................CWR

Use to specify if an unacknowledged diagnostic will cause the beeper to beep.

NO 0 beeping is disabled for an unacknowledged diagnostic.

YES 1 an unacknowledged diagnostic will cause the beeper to beep

21 Diagnostics: Flash/ Beep Rate (DFLSHRAT)................................................................. CWR

Diagnostic flash rate for LED, display and beeper.

SLOW 0 flash rate as set by slow off and on counts.

FAST 1 flash rate as set by fast off and on counts.

2-29

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 151 152

Sin comentarios

Micromod MOD: 30ML Functions Data Base Reference Manual de usuario Pagina 37