Micromod Micro-DCI: 53MC5000 Multi-Loop Process Controller Manual de usuario descargar pdf (Pagina 15)

2.7.1 STATUS DISPLAY 1 LOADER

The Status Display 1 (SDT1) Loader module allows operator push button inputs to be acted upon

by the FCS function block by mapping SDT1 into the FCS program. Operation of SDT1 is ex-

plained in Section 4, Displays, of IB 53MC5000, Revision 2.

For example, by loading a 103 into datapoint B105, the SDT1A output (L103) is softwired with FCS

to operate CCO0 (input is B105) and display a message on the SDT1 status display each time the

F3 push button is pressed. The ten character message is configured with the SDT1 parameters

listed in the table that follows to alternately appear as one of two five character fields, such as

OPEN or CLOSE, each time the F3 push button is pressed. Before the F3 push button is pressed,

the cursor on the SDT1 status display is used to select one of the eight (1A-1H) active SDT1 out-

puts (in this case it would be the top display line, which is SDT-1A). An illustration of the SDT1

module follows the table.

Status Display 1 Module Parameters

LEGEND

LABEL MODE ALARM

ENABLE

ALARM

ACKNOWLEDGE

MODIFY

DISABLE

OUTPUT

SDT-1A A064 L360 L376 L392 L328 L103

SDT-1B A065 L361 L377 L393 L329 L102

SDT-1C A066 L362 L378 L394 L330 L101

SDT-1D A067 L363 L379 L395 L331 L100

SDT-1E A068 L364 L380 L396 L332 L083

SDT-1F A069 L365 L381 L397 L333 L082

SDT-1G A070 L366 L382 L398 L334 L081

SDT-1H A071 L367 L383 L399 L335 L080

FCS 53MC5000 Flexible Control Strategies

2-8

STAT1

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 200 201

Sin comentarios

Micromod Micro-DCI: 53MC5000 Multi-Loop Process Controller Manual de usuario Pagina 15