Micromod RetroPAK: MOD 30 Installation Manual Manual de usuario descargar pdf (Pagina 25)

MOD 30ML Replacement for MOD 30 Instruments

REPLACEMENT PROCEDURE

3. Position the communication jumpers, Figure3-1, as follows:

• If an ICN Module is installed, place the jumpers as shown for ICN and RS-232.

• If the ICN is to use the built-in communication circuit (no ICN module), place the

jumpers as shown for ICN ONLY.

• If the ICN is not being used, place the jumpers as shown for RS-232 ONLY.

4. Insert the instrument into its housing and tighten the screws to draw the front panel tight

against the housing.

Communication Jumper Locations

ICN & RS-232 ICN Only RS-232 Only

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 35 36

Sin comentarios

Micromod RetroPAK: MOD 30 Installation Manual Manual de usuario Pagina 25