Micromod Micro-DCI: 53MT6000 Micro-Tools Manual de usuario descargar pdf (Pagina 83)

53MT6000 INSTRUCTION MANUAL

Database Editor 67

7.4.10 TOTALIZER Menu

There are eight Totalizer modules that can be configured. The TOT module parameters can be configured

by clicking on the appropriate entry window or button. The window shown in Figure 7-19 will be displayed.

Any parameter can be selected and changed.

When the TOT button is selected from the Database Editor, a window opens containing the configurable

parameters listed below. The database locations where these values are stored for TOT0 are shown in

brackets [ ].

Figure 7-19. TOTALIZER Configuration Window

ENTRY EXPLANATION

Module ID: Selects the Module to be configured. Use the up or down arrow

buttons to cycle through the control module selection.

Tagname: Tagname (title) of the TOTALIZER MODULE.

Eng. Units: Engineering Units, up to 10 characters.

DB Input: Database address of the point to be totaled; for example, C100.

Clicking on the button opens the following display:

Dropout: To set minimum input value of Module; input values less than this

value will be treated as 0. Clicking on the button opens the following

display:

1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 143 144

Sin comentarios

Micromod Micro-DCI: 53MT6000 Micro-Tools Manual de usuario Pagina 83