Micromod Micro-DCI: 53MT6000 Micro-Tools Manual de usuario descargar pdf (Pagina 25)

53MT6000 INSTRUCTION MANUAL

Installati on 9

4. Connect the Instrument DataLink cable to the TOP connector at the rear of the SUPERVISOR-

PC card.

3.3.2.4 Connecting Micro-Tools to the DataLink Network

Once a DataLink SUPERVISOR card is installed in the computer, connect the SUPERVISOR card to the

DataLink network using the port provided on the card.

If your controllers have standard rear terminal connections, making this connection requires only one

cable. This cable has a 10-pin connector with a grounding lug on one end and five bare wires on the other.

Cables may be ordered using the part numbers shown in Table 2 in Figure 3-6.

1. Plug the 10-pin connector on the cable to the port at the top of the SUPERVISOR card. This

connector is the key to insuring a proper installation.

2. Connect the connector's grounding lug to the same ground as the DataLink instruments'

power common.

Figure 3-4. SUPERVISOR-PC Jumper Terminal Locations

Table 3-1. Selecting Supervisor Board Base Address With Jumpers J3, J4, and J5

Base

Address

J3 J4 J5

300H AB AB AB

310H AB AB BC

380H AB BC AB

390H AB BC BC

3A0H BC AB AB

280H BC AB BC

290H BC BC AB

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 143 144

Sin comentarios

Micromod Micro-DCI: 53MT6000 Micro-Tools Manual de usuario Pagina 25